Astra L4-1.8L (2009)
5. Remove the boot clamps for the boot on the wheel side (1).
Mark the position of the boot at the axle shaft side.
6. Pull the boot (1) on the transmission side of the axle shaft joint off over the axle shaft, arrow.
Installation Procedure
1. Prepare the axle shaft joint on the transmission side
*
Wash out the joint.
*
Fill cavities in the joint with special grease.
2. Attach the new boot on the transmission side.
Slide on the new boot up to mark on transmission side.
3. Attach the new boot clamps with J 22610 .
4. Push the boot onto the axle shaft on the wheel side.
5. Drive the joint onto the axle shaft with a rubber hammer until the retaining ring engages on the axle shaft.