ION L4-2.0L SC (2007)
1. Remove the cap from the nipple on the brake primary reservoir.
2. Remove the plug from the auxiliary reservoir hose end.
3. Connect the quick-connect fitting on the reservoir hose to the primary reservoir. Ensure that the hose is fully seated to the reservoir.
Notice: Refer to Fastener Notice.
4. Install the brake master cylinder auxiliary reservoir mounting bolts.
Tighten the bolts to 10 N.m (89 lb in).
5. Fill the brake master cylinder auxiliary reservoir.
6. Remove the shop towels and discard into an approved container.
7. Connect the electrical connector to the brake fluid level sensor, then press forward on the CPA tab of the connector to secure.
8. Install the cover to the underhood electrical center.
Brake Master Cylinder Auxiliary Reservoir Replacement (Manual Transmission)
Brake Master Cylinder Auxiliary Reservoir Replacement (Manual Transmission)
Caution: Refer to Brake Fluid Irritant Caution.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.
Removal Procedure