ION L4-2.2L VIN F (2004)
Caution: Use care when working around the roof rail inflator module because sharp objects may puncture the roof rail airbag and the airbag will
not deploy correctly.
In order to avoid personal injury, if any part of the module is damaged replace the entire module
1. Using a small, flat-bladed tool, remove the fastener trim cover.
2. Remove the screw from the windshield garnish molding.
3. Disengage the retaining clips by pulling on the garnish molding.
4. Lift the bottom of the molding out from between the windshield pillar and the instrument panel. Remove the molding from the vehicle.
Installation Procedure
1. Position the windshield garnish molding in the vehicle. Install the molding by pushing the molding over the clip locations.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the screw to the windshield garnish molding.
Tighten the screw to 2.3 N.m (21 lb in).
3. Install the fastener trim cover.
4. Replace the door seal over the trim edge.