saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Procedures|Page 12155 > < Procedures|Page 12153
Page 4
background image

2. Connect the rear drain hose to the sunroof module.
3. Connect the rear drain hose to the attachments on the rear window pillar.
4. Push the rear drain hose and grommet into the hole in the rear compartment panel until the grommet is fully engaged.
5. Install the rear compartment trim panel.
6. Install the headliner.

Sunroof Drain Inspection and Cleaning

Sunroof Drain Inspection and Cleaning

Drain Hose Routing

A drain trough encircles the sunroof window panel and water is drained off by the drain hoses located at each corner of the housing. A drain channel
spans across the sunroof module at the rear of the window panel and directs water into the trough.

1. Check to ensure the front drain hoses are routed down the windshield pillars and out the center of the pillar between the door hinges. Make sure

the hoses are not kinked. Replace any torn or cracked hose. Refer to Sunroof Drain Hose Replacement - Front  (See: Removal and
Replacement/Sunroof Drain Hose Replacement) .

2. Check to ensure the rear drain hoses are routed through the rear pillars and out of the rocker panel. Make sure the rear hoses are properly routed in

the metal roof slot and taped in place. Replace any torn or cracked hose. Refer to Sunroof Drain Hose Replacement - Rear  (See: Removal and
Replacement/Sunroof Drain Hose Replacement - Front (Monte Carlo)) .

Plugged Drain Hose

If a waterleak has occurred check for a plugged drain hose at each corner of drainage system.

1. Open the sunroof window.
2. To test for blockage, pour a small container of water into the module housing drain trough. Check each corner to confirm the drain hose is draining

water.

Caution:  Wear safety glasses in order to avoid eye damage.

3. Use compressed air, 35 psi or less to blow out any drain hose that is plugged.
4. Test the system again.
5. If the hose remains plugged, check to see it is properly routed and does not have a kink. Refer to Drain Hose Routing.
6. Remove any hoses that remain plugged. Refer to Sunroof Drain Hose Replacement - Front  (See: Removal and Replacement/Sunroof Drain Hose

Replacement) or to Sunroof Drain Hose Replacement - Rear  (See: Removal and Replacement/Sunroof Drain Hose Replacement - Front (Monte
Carlo)) .

7. Remove the blockage.

1. Push mechanics wire through the hose to remove the obstruction.
2. Use compressed air in order to blow out any remaining material.

Procedures|Page 12155 > < Procedures|Page 12153