ION L4-2.2L VIN F (2004)
Brake Pedal Assy: Service and Repair
Brake Pedal Assembly Replacement
Removal Procedure
1. Release the Electric Power Steering (EPS) wiring harness from the brake pedal bracket.
2. Remove the cruise control module, if equipped, from the brake pedal bracket.
3. Remove the accelerator pedal mounting nuts. Reposition the accelerator pedal to improve tool access to the LH, lower booster mounting nut.
4. Loosen the brake booster mounting nuts.
5. Remove the retaining clip (4) and washer (3) from the brake pedal.
6. Release the brake booster pushrod (2) from the brake pedal.
7. Remove the brake booster mounting nuts.
8. Remove the brake pedal bracket-to-steering column bracket bolt (1).
9. Lower the brake pedal assembly to improve access for switch removal.
10. Remove the stop lamp switch from the pedal bracket.
11. Remove the cruise control release switch, if equipped, from the pedal bracket.
12. Remove the brake pedal assembly from the vehicle.
Installation Procedure