ION L4-2.2L VIN F (2004)
2. Pull back on the Connector Position Assurance (CPA) tab of the electrical connector, then disconnect the connector from the brake fluid level
sensor.
3. Using needle nose pliers, carefully depress the retaining tabs on the end of the brake fluid level sensor (1), and press the sensor through the brake
master cylinder auxiliary reservoir (2) to remove.
Installation Procedure
1. Install the brake fluid level sensor (1) to the brake master cylinder auxiliary reservoir (2), Press the sensor into place to secure the sensor retaining
tabs.
2. Connect the electrical connector to the brake fluid level sensor, then press forward on the CPA tab of the connector to secure.
3. Install the cover to the underhood electrical center.
Master Cylinder Replacement
Master Cylinder Replacement
NOTICE: There is a first design and second design of brake pipe flare for the hydraulic brake pipes and system components used on this vehicle. Do