ION L4-2.2L VIN F (2004)
10. Raise and support the vehicle.
11. If the park brake cable is being reused, release the tab on the underbody retainer (2) and remove the park brake cable from the retainer.
12. If a new park brake cable will be installed, release the underbody retainer (2) from the vehicle underbody.
Important: Do NOT pull on the park brake cable to release the C-shaped retainer (1) on the cable from the bracket at the rear axle trailing arm pivot.
13. Using a suitable tool, carefully pry against the outboard side of the C-shaped retainer (1) on the park brake cable, to release the retainer from the
bracket at the rear axle trailing arm pivot.
14. Remove the cable from the opening in the vehicle underbody.
15. Remove the rear tire and wheel assembly.
16. Remove the brake drum.
17. Using a flat-bladed screwdriver, depress the visible retaining tab (1) on the park brake cable fitting, then tilt the released side of the cable end back
into the backing plate
18. Rotate the park brake cable to expose the other retaining tab.
19. Using a flat-bladed screwdriver, depress the remaining retaining tab on the park brake cable fitting, and release the cable fitting from the backing
