ION L4-2.2L VIN F (2004)
5. Separate the EBCM (1) from the BPMV (2) by carefully pulling apart.
Installation Procedure
1. Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
2. Install the EBCM (1) to the BPMV (2). Use care when aligning the EBCM (1) to the BPMV electrical terminals (3).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the 4 EBCM-to-BPMV retaining bolts (1). Tighten the bolts in a crisscross pattern.
-
Tighten the bolts to 3 Nm (27 inch lbs.).
4. Connect the electrical connector to the EBCM.
5. Turn the ignition switch to the ON position. DO NOT start engine.