ION L4-2.2L VIN F (2004)
4. Ensure that the alignment notches are aligned with the camshaft sprocket.
5. Install the intake camshaft.
6. Install the camshaft bearing caps.
Notice: Refer to Fastener Notice in Service Precautions.
7. Tighten the camshaft bearing cap bolts in increments of 3 turns until they are seated.
^
Tighten the camshaft bearing cap bolts to 10 Nm (89 inch lbs.).
8. Apply a 5 mm (0.197 inch) bead of Permatex Anaerobic Gasket Maker 51813 (or equivalent), to the rear intake camshaft bearing cap.
9. Install the rear intake camshaft bearing cap bolts.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
10. Install camshaft sprockets onto the camshafts.
11. Hand tighten NEW camshaft sprocket bolts.
