ION L4-2.2L VIN F (2004)
Cylinder Liner: All Technical Service Bulletins
Engine - Loss of Coolant/No External Leaks Evident
File in Section: 06 - Engine/Propulsion System
Bulletin No.: 03-06-123-001
Issue Date: November, 2003
TECHNICAL INFORMATION BULLETIN
Subject:
Slight Loss of Coolant or Low Coolant Light Coming On with No Signs of External Leaks (Perform Service Procedure in this Bulletin)
Models Affected:
2003-2004 Saturn VUE and ION
2004 L300 Vehicles
with 2.2L Engine (VINs D, F - RPO L61)
Attention:
Parts Manager and Technician
Condition:
Some customers may comment that the low coolant light is coming on and/or the coolant level is low with no external leaks visible. Low coolant may be
accompanied by one of the following when the engine is cold:
^
engine being difficult to start
^
engine misfire for several seconds
^
white smoke or coolant odor from the tailpipe
Cause:
This condition may be caused by porosity in the aluminum of the cylinder head casting.
Correction:
Follow service procedure in this bulletin.
Service Procedure:
Diagnostic Checks
1.
Verify low coolant level.
2.
Inspect all coolant hoses and connections for coolant leaks.
^
If leaks are found, replace hoses and/or tighten clamps as necessary and return vehicle to the customer.
^
If no leaks are found, check engine oil for signs of coolant contamination. Add black light dye (SA9176NE) to the cooling system and start
engine. Run engine until it is at normal operating temperature 180°F (82°C) to allow the dye to circulate through the system.
3.
Pressurize cooling system to 25 psi (172 kpa) and monitor gauge for pressure loss during remaining inspections.
^
Inspect complete cooling system hoses and connections for visual signs of external leaks using the black light (J42220).
^
Remove spark plugs and inspect threads for wetness from coolant and check with black light (J42220).
^
Using a flashlight, inspect combustion chambers for any sign of wetness from coolant.
4.
If no pressure loss and no signs of internal or external leaks, return vehicle to customer.
5.
If pressure gauge shows loss of pressure and there is evidence of external leakage from hoses or other external cooling system components, correct
