ION L4-2.2L VIN F (2004)
1. Install the filter to the cap.
2. Install the oil filter cap with filter.
Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.
Notice: Refer to Fastener Notice in Service Precautions.
Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.
3. Use a 32 mm (1 1/4 inch) socket on the hex on the top of the oil filter cap, or an oil filter wrench on the outside diameter of the oil filter cap.
^
Tighten the oil filter cap until fully seated, DO NOT exceed 25 Nm (18 ft. lbs.).
4. Install the oil pan drain plug.
^
Tighten the oil pan drain plug to 25 Nm (18 ft. lbs.).
5. Lower the vehicle.
6. Fill the engine with oil.