ION L4-2.2L VIN F (2004)
1.
Check all tire pressure readings and record this information on the repair order.
2.
Inspect all four tires for any premature, irregular or excessive tire wear.
^
If the inside edge of the tire is worn to the wear indicators, replace the affected tire(s) and continue with the next step.
^
If the inside edge of the tire is not worn to the wear indicators, rotate the tires and continue with the next step.
3.
Set the tire inflation pressure per the vehicle tire placard on the driver's door.
4.
Inspect the fuel level. The fuel tank should be full or the vehicle should have compensating load added.
Important:
A printout from the alignment machine of "before" and "after" specifications must be attached to the hardcopy of the CSO.
5.
Measure the front and rear alignment angles and record the readings.
Important:
When performing adjustments to vehicles requiring a 4-wheel alignment, set the rear wheel alignment angles first in order to obtain proper
front alignment angles.
Important:
The service equipment used to measure wheel alignment may or may not contain the correct alignment specifications for Saturn ION vehicles.
6.
If any alignment angle is outside of specification, then adjust the angle or angles until they are within vehicle specifications.
7.
Adjust front total toe to the new preferred setting (+ 0.20° +/- 0.20°) for tire wear issues.
8.
Road test the vehicle in order to verify the steering wheel is straight.
Claim Information
U.S. Retailers: To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System for E2000 (Toe,
Front - Adjust) or E2020 (Wheel Alignment - Check and/or Adjust). If the tire replacement is necessary due to the inside edge of the tire being worn to
the wear indicators, use the appropriate tire replacement labor and relate it to either E2000 or E2020. Tires are to be returned to the tire manufacturer.
Important:
A printout from the alignment machine of "before" and "after" specifications must be attached to the hardcopy of the CSO.
Canadian Retailers: To receive credit for this repair during the warranty coverage period, submit a claim through the normal procedures for E2000 (Toe,
Front - Adjust) or E2020 (Wheel Alignment - Check and/or Adjust). NOTE: Refer to Home Office Letter 1997-070 for guidelines on usage of E2000
and E2020. If the tire replacement is necessary due to the inside edge of the tire being worn to the wear indicators, refer to bulletin 01-03-10-003B for
tire handling procedures.
Disclaimer
Technical Service Bulletin # 05-03-07-001B
Date: 050727
Alignment - Premature/Irregular Tire Wear
Bulletin No.: 05-03-07-001B
Date: July 27, 2005
TECHNICAL
Subject:
Premature and/or Irregular Tire Wear (Set Front Sum Toe and Rotate Tires as Necessary)
Models:
