ION L4-2.2L VIN F (2004)
Important: Do not use ATF (P/N 21005966 or P/N 21019223), these fluids are not compatible with this transmission.
8. Add approximately 6.0-6.5 liters (6-7 quarts) of Saturn DEX-CVT(R) Fluid P/N 22688912 to the transmission.
9. Install a scan tool.
10. With the vehicle on a flat and level surface, start the vehicle.
11. Circulate the fluid through the transmission using the following procedure:
11.1.
With the brake applied, shift the transmission from the park (P) position to the reverse (R) position for 10 seconds.
11.2.
Shift the transmission to the drive (D) position for 10 seconds.
11.3.
Shift the transmission to the park (DP) position, allowing the engine to remain running.
12. Raise the vehicle.
13. Remove the lower tube assembly drain plug and discard.
14. Follow the following procedure to assure proper fluid level:
^
If the fluid drains down at a steady stream from the opening, allow the fluid to drain until it stops.
^
If no fluid or a very small amount of fluid drains, add fluid to the transmission until a steady stream starts to drain. Stop adding fluid
immediately. Allow the fluid to drain until it stops.
15. Install a new lower tube assembly plug and clean any excess fluid from the transmission.
^
Tighten the plug to 11 Nm (97 inch lbs.).
16. Lower the vehicle
Important: Do not remove the lower tube assembly drain plug.
17. With the scan tool, record the TRANS FLUID TEMP.
^
If the TRANS FLUID TEMP is 20'C (680F) or less, add 0.47 liter (0.5 quart) of fluid to the transmission.
^
If the TRANS FLUID TEMP is 40°C (104°F), add 0.71 liter (0.75 quart) of fluid to the transmission.
^
If the TRANS FLUID TEMP is 60°C (140°F), add 0.95 liter (1.0 quart) of fluid to the transmission.
^
If the TRANS FLUID TEMP is 80°C (176°F), add 1.2 liter (1.25 quart) of fluid to the transmission.
18. Turn OFF the ignition.
19. Add Saturn DEX-CVT additive P/N 22697447 to the transmission using the provided applicator. Inject the entire contents into the transmission.