ION L4-2.2L VIN F (2004)
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the flat washer (74), lock tab washer (77) and nut (78) to the manual shaft.
^
Tighten the nut to 7 Nm (62 inch lbs.).
Important: The transmission manual shaft must be in the neutral position when adjusting the park/neutral position switch.
4. If installing the old park/neutral position switch, perform the following procedure:
4.1.
Install the J 45404 to the manual shaft in order to align the pointer to the neutral base line.
4.2.
Rotate the park/neutral position switch as necessary to align the neutral base line to the pointer.
4.3.
Remove the J 45404 from the manual shaft.
5. Tighten the park/neutral position switch bolt and stud.
^
Tighten the bolt and stud to 25 Nm (18 ft. lbs.).