ION L4-2.2L VIN F (2004)
2. Install the SDM to the floor pan.
3. Point the arrow on the SDM toward the front of the vehicle.
4. Install the SDM mounting nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 10 N.m (89 lb in).
5. Install the SDM harness connector to the SDM.
6. Install the CPA to the SDM harness connector.
7. Install the floor console.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 (Coupe) SIR Disabling and Enabling Zone 8 (Sedan).
9. Program the new SDM into the Dash Integration Module. See: Testing and Inspection/Programming and Relearning
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly.