ION L4-2.2L VIN F (2004)
Transmission Speed Sensor: Service and Repair
Input Shaft Speed Sensor Replacement
Input Shaft Speed Sensor Replacement
Removal Procedure
1. Disconnect the wiring harness from the input speed sensor.
Important: Do not damage the input speed sensor or transaxle case.
2. Remove the input speed sensor bolt/screw (72).
3. Remove the input speed sensor (73), and the input speed sensor O-ring (71).
4. Inspect the input speed sensor for damage.
Installation Procedure
1. Apply automatic transmission fluid to the new input speed sensor 0-ring seal (71).
2. Install the new input speed sensor 0-ring seal (71) onto the input speed sensor (73).
3. Install the input speed sensor (73) into the transmission case assembly (17).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the input speed sensor bolt (72).
^
Tighten the input speed sensor bolt (72) to 4.5 Nm (40 inch lbs.).