ION L4-2.4L (2007)
Brake Drum: Testing and Inspection
Brake Drum Diameter Measurement
Brake Drum Diameter Measurement
Caution: Refer to Brake Dust Caution.
1. Clean the brake shoe lining contact surface of the brake drum with denatured alcohol or an equivalent approved brake cleaner.
2. Using a brake drum micrometer calibrated in thousandths-of-an-inch, measure and record the largest diameter of the brake drum at four or more
points, equally spaced around the drum.
Ensure the measurements are only taken within the brake shoe lining contact area. The micrometer must be positioned the same distance from the
outside edge of the drum for each measurement.
3. Compare the largest diameter measurement recorded to the following specifications:
^
Brake drum maximum allowable diameter after refinishing: 230.50 mm (9.075 in).
^
Brake drum discard diameter: 231.0 mm (9.094 in).
4. If the largest diameter measurement of the brake drum is less than the allowable inside diameter after refinishing specification; the drum may be
refinished, depending upon surface and wear conditions.
5. If the largest diameter measurement of the brake drum is equal to or greater than the maximum allowable diameter after refinishing specification;
the drum may not be refinished.
6. If the largest diameter measurement of the brake drum is equal to or greater than the discard diameter specification; the drum requires replacement.