ION L4-2.4L (2007)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement (Disc Brake)
Wheel Stud Replacement (Disc Brake)
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake rotor.
4. Using the J 43631, remove and discard the wheel stud.
Installation Procedure
1. Install the NEW wheel stud into the wheel bearing hub.
2. Add enough washers (3) in order to draw the stud into the hub.
3. Install the wheel nut (1) with the flat side against the washers.
4. Tighten the wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing hub flange.
5. Remove the wheel nut (1) and the washers (3).
6. Install the brake rotor.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
Wheel Stud Replacement (Drum Brake)