L100 L4-2.2L VIN F (2001)
INSTALLATION
1. Lubricate new reservoir seals with clean brake fluid and install into master cylinder.
2. Install reservoir into master cylinder. Be sure locking tabs are engaged.
3. Install low brake fluid switch and electrical connector.
4. Vehicles equipped with manual transaxles must install clutch hydraulic feed line to master cylinder reservoir.
NOTICE: Use only DOT 3 brake fluid from a clean, sealed container. Do not use any fluid from a container which is wet with water. Do not use
DOT 5 silicone fluid.
5. Fill brake reservoir with clean brake fluid up to "MAX" mark on reservoir.
6. Bleed brake system.
