L100 L4-2.2L VIN F (2001)
6. Select a paved outdoor location to perform deployment. Clear a space on the floor and make certain no loose objects or flammable material are
within 4.6 m (15 ft.) of the inflator module. Make sure you have sufficient ventilation.
7. When deploying a driver inflator module, place the inflator module in the center of the space with the vinyl trim cover facing up.
8. When deploying a passenger inflator module, refer to the following instructions:
^
Place the SIR Deployment Fixture SA9413NE in the center of the cleared area.
^
Fill plastic reservoir in deployment fixture with water or sand to provide sufficient stabilization of fixture during deployment.
^
Attach passenger inflator module in the deployment fixture using the Flange/Arm Mounting Method shown in illustration.
^
SECURELY HAND-TIGHTEN ALL FASTENERS PRIOR TO DEPLOYMENT.
9. When deploying a curtain inflator impact module-front, refer to the following instructions:
^
Place the SIR Deployment Fixture SA9413NE in the center of the cleared area.
^
Fill plastic reservoir in deployment fixture with water or sand to provide sufficient stabilization of fixture during deployment.
^
Attach curtain inflator module in the deployment fixture using the Flange/Arm Mounting Method shown in illustration.
^
SECURELY HAND-TIGHTEN ALL FASTENERS PRIOR TO DEPLOYMENT.
