L100 L4-2.2L VIN F (2001)
12. Install caliper mount bracket onto knuckle.
Torque: Caliper Mount Bracket-to-Knuckle: 95 Nm (70 ft. lbs.)
13. Install stabilizer bar link to strut assembly.
Torque: Stabilizer Bar-to-Stabilizer Bar Link: 65 Nm (48 ft. lbs.)
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts to
loosen in service.
14. Position wheel onto hub.
15. Install wheel bolts and tighten in a star pattern.
15.1.
Hand tighten all five wheel bolts.
15.2.
Use a torque wrench to tighten wheel bolts using a star pattern.
Torque: Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
15.3.
Use a torque wrench to final tighten wheel bolts using a star pattern.
Torque: Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
16. Lower vehicle from hoist.
17. Depress brake pedal and tighten axle to hub nut in the following sequence:
Torque: Nut to: 115 Nm (85 ft. lbs.) to seat the bearing back nut off and retighten to: 20 Nm (15 ft. lbs.) using a torque angle gauge turn nut
additional 90 degrees. If required, continue turning nut until a cotter hole aligns with castle nut slot.
18. Install cotter pin.
19. Perform vehicle wheel alignment.
