L200 L4-2.2L VIN F (2002)
9. Remove the rear upper garnish molding. Refer to Rear Upper Garnish Molding Replacement (See: Trim Panel/Service and Repair/Rear Upper
Garnish Molding Replacement).
10. If the vehicle is equipped with OnStar(R), perform the following procedure:
1. Disconnect the harness from the rearview mirror.
2. Disconnect the coaxial cables from the antennas on the front and rear glass.
3. Twist the microphone bezel counterclockwise to drop down from the headliner.
4. Disconnect the microphone harness.
5. Remove the right rear seat bolster.
6. Disconnect the harness from the rearview mirror.
7. Disconnect the coaxial cables from the antennas on the front and rear glass.
8. Twist the microphone bezel counterclockwise to drop down from the headliner.
9. Disconnect the microphone harness.
10. Remove the right rear seat back bolster. Refer to Rear Split Folding Seat Back Bolster Replacement (See: Seats/Seat Back/Service and
Repair/Removal and Replacement/Rear Split Folding Seat Back Bolster Replacement).
11. Disconnect the wiring harness and cables at OnStar(R) module under parcel shelf located in the trunk.
12. Pull back the carpet in the trunk and remove the OnStar(R) harness from the body side inner panel.