L200 L4-2.2L VIN F (2002)
1. Position the garnish molding to the vehicle.
2. Install the garnish molding by pushing gently at the clip locations.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the rear seat shoulder belt to the garnish molding.
The fasteners to 35 Nm (26 lb ft).
4. Install the rear seat shoulder belt fastener cover.
5. Route the shoulder belt into the garnish molding at the access slot.
6. Raise the rear seat back.
7. Ensure proper operation of the rear seat shoulder belt.
Windshield Garnish Molding Replacement
Windshield Garnish Molding Replacement
Removal Procedure