L200 L4-2.2L VIN F (2002)
two or three coats are required to obtain hiding. Do not melt in the dry edge of the basecoat color after finishing the blend; the clearcoat will take
care of this.
13. Allow the final coat of basecoat color to flash for at least 15 minutes, but no longer than 2 hours, before applying the clearcoat.
14. Mix two component clearcoat. Refer to product label instructions.
15. Apply two or three medium wet coats of clear over the entire panel. Use 276 - 344 kPa (40-50 psi) of air pressure at the gun. Allow five to 10
minutes flash time between coats.
