L200 L4-2.2L VIN F (2002)
5. Disconnect rear park brake cable to front park brake cable and discard clip.
6. Remove park brake cable from brake backing plate.
INSTALLATION
1. Install park brake cable into backing plate.
NOTICE: A new attachment clip must be used whenever park brake cables are disconnected.
2. Using a new clip, attach the rear park brake cable to the front park brake cable.
3. Assemble rear drum brakes.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts
to loosen in service.
4. Install wheel and tire assemblies onto hub.
5. Install wheel bolts and tighten in a crisscross pattern.
5.1
Hand tighten all five wheel bolts.
5.2
Use a torque wrench to tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
5.3
Use a torque wrench to final tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
6. Adjust park brake cable.
7. Lower vehicle from hoist.