L200 L4-2.2L VIN F (2002)
6. Remove valve spring cap, retainers and release spring tension.
7. Remove cap and spring.
8. Remove valve stem seal using Valve Seal Remover/Replacer SA9102E-A.
INSTALLATION
NOTICE: If a valve stem seal is removed after it has been installed, it must be discarded. The valve stem lock groove will cut the seal's lip during
removal. Use extreme care not to damage valve stems when installing retainers.
IMPORTANT: Before each valve stem seal is installed, oil the valve stem seal and guide. If a valve stem seal is removed, it must be discarded.
1. Inspect valve stem for scratches, scores, and scuffs. Spray valve stem and guide with clean lubricating oil to remove any debris that may be present
on valve stem or top of guide.
2. Oil valve guide and valve stem. Install valve stem oil seal with service tool SA9102E.
