L200 L4-2.2L VIN F (2002)
4. Using external snap ring pliers, remove snap ring.
NOTE: Do not remove pulley without puller adapter. If A/C compressor shaft is pressed on, A/C compressor will be damaged.
5. Position the Puller Center SA9149AC-2 on end of A/C compressor shaft.
IMPORTANT: Make sure to hook the puller jaw behind the pulley only, not the coil.
6. Install three-jaw puller on A/C compressor pulley. Tighten center bolt to remove pulley assembly.
IMPORTANT: To enable easier removal of screws, lightly tap on the end of the screwdriver with a plastic hammer.
