L200 L4-2.2L VIN F (2002)
10. Remove the linkage installer and install the NEW tie rod end nut.
Tighten
Tighten the tie rod end-to-steering knuckle nut to 60 Nm (44 lb ft).
11. Install the wheel and tire assemblies onto the hub.
12. Install the wheel bolts and tighten them in a crisscross pattern.
12.1. Hand tighten all 5 wheel bolts.
12.2. Use a torque wrench to tighten the wheel bolts using a crisscross pattern.
Tighten
Tighten the wheel bolts -- initial torque to 63 Nm (46 lb ft).
12.3. Use a torque wrench to final tighten the wheel bolts using a crisscross pattern.
Tighten
Tighten the wheel bolts -- final torque to 125 Nm (92 lb ft).