L300 V6-3.0L VIN R (2001)
30. Using a sharp knife, carefully cut hole in raised portion of rear compartment side carpet at U-Nut location to provide room for bracket to go
through carpet and attach to vehicle.
31. Align bracket over side trim ensuring bracket is straight.
32. Mark with a pen or sharp tool where Riv-Nut holes are beneath it.
33. Mark with a pen or sharp tool where connector should come through (near lower edge of bracket.)
34. Pull bracket away.
35. Using a sharp knife, carefully cut holes in rear compartment side carpet for fasteners to go through into Riv-Nuts.
36. Using a sharp knife, carefully cut slit in rear compartment side carpet for connector to go through.
37. Pull Body CD jumper through trunk side carpet slit.