L300 V6-3.0L VIN R (2001)
4. Remove the electrical connectors from the rear window defogger bus bars. Mark both the inside and outside of the glass with tape to identify the
electrical connector locations. Position the electrical connectors so not to damage the wiring/connectors when using the urethane power removal
tool.
5. Remove the wiper arm, finish cap, nut, and washer.
6. Remove the spacer, shaft nut, washer, and bezel.
7. Apply two 15 cm (6 in) pieces of duct tape to the top and bottom of the glass to prevent it from falling out when the urethane adhesive is cut.