L300 V6-3.0L VIN R (2001)
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the sunshade inner retainer clip.
Tighten the inner sunshade support fasteners to 15 Nm (11 lb ft).
7. Connect the sunshade wiring harness if the vehicle has an illuminated sunshade.
8. Install the sunshade assembly.
Tighten the sunshade-to-headliner fasteners to 15 Nm (11 lb ft).
9. Install the assist handle assembly.
10. Connect the electrical harness at the liftgate.
11. If equipped with Onstar, route and attach the wiring harness from the headliner to the module.
12. On Onstar vehicles only, make connections at the Onstar module and body harness located under the right seat bolster.
13. If equipped with Onstar, install the front load floor. Refer to the Front Load Floor.
