L300 V6-3.0L VIN R (2001)
1. Install bleeder valve into caliper body assembly.
Torque: Caliper Bleeder Valve: 6 Nm (53 inch lbs.)
2. Install bleeder valve cap.
NOTICE: Make sure seal is not twisted.
3. Lubricate new piston seal with clean brake fluid and install seal into caliper seal groove.
4. Install piston boot into caliper. Boot must sit in caliper groove.
5. Lubricate outside diameter of piston with clean brake fluid.
NOTICE: Inner lip of piston boot must engage in groove of piston.
6. Install piston into caliper body. Push piston all the way to bottom of caliper bore.
INSTALLATION
1. Make sure caliper piston is bottomed fully in its caliper bore.