L300 V6-3.0L VIN R (2001)
Vacuum Brake Booster: Adjustments
POWER BRAKE BOOSTER PUSH ROD ADJUSTMENT
IMPORTANT: The push rod length is adjusted at the factory and should not need adjustment. If the adjustment has been tampered with, the
following procedure should be used.
1. Remove brake booster from vehicle.
IMPORTANT: The dimension is measured from the brake booster mounting surface to the end of the brake booster push rod connector.
2. Loosen adjuster jam nut.
3. Adjust brake booster push rod connector length to 184.75 mm ± 0.25 mm (7.27 inch ± 0.01 inch).
4. Tighten adjuster jam nut to brake booster push rod connector.
Torque: Adjuster Jam Nut-to-Brake Booster Push Rod Connector: 18 Nm (159 inch lbs.)