L300 V6-3.0L VIN R (2001)
IMPORTANT: Ensure pin on exhaust camshaft is approximately in the 1 o'clock position and/or that the pin on intake camshaft is approximately in
the 11 o'clock position to allow for minimal load on camshaft when installing bearing caps.
3. Apply a small amount of Loctite 518 (or equivalent) on forward edge of front bearing caps to ensure an adequate seal between bearing cap and
cylinder head.
4. The bearing caps for rear (CYL 1, 3, 5) cylinder head are marked L1-L8 (Cylinder 1, 3, 5).
5. Install camshaft bearing caps in their appropriate position.