L300 V6-3.0L VIN R (2001)
10. Inspect the Universal SIR Deployment Harness SA9207Z-A and the appropriate pigtail adapter, Driver's Air Bag Adapter SA9414Z for the driver
airbag or SIR Deployment Adapter SA9207Z for the passenger airbag or curtain airbag, for damage. Replace as needed.
11. Short the two Universal SIR Deployment leads (2) together by fully seating one banana plug into the other. The Universal SIR Deployment
Harness shall remain shorted and shall not be connected to a power source until the air bag is to be deployed.
12. Connect the appropriate pigtail adapter (1) to the Universal SIR Deployment Harness (2).
IMPORTANT: Make sure that the adapter connector is fully seated into inflator module connector. Failure to fully seat connectors may leave the
shorting bar located in the inflator module connector active and may result in non-deployment of inflator module.
13. Extend the SIR deployment harness and adapter to full length from the deployment fixture or area.
14. Connect the inflator module (1) to the adapter (2) on the SIR deployment harness.
15. Verify driver inflator module is resting with its vinyl trim cover facing up or that the passenger inflator or curtain inflator is mounted properly to
the deployment fixture.
16. Verify area around the inflator module is clear of all people, loose objects, or flammable material.
IMPORTANT:
^
When deploying an inflator module, the rapid expansion of gas is very loud which may startle the uninformed. Notify the people in the immediate
area that an inflator module will be deployed.
^
When the inflator module deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of a deploying inflator
module due to the force of rapid gas expansion inside the airbag.
