L300 V6-3.0L VIN R (2001)
4. Tighten steering knuckle to strut assembly fasteners in the following sequence using Torque-to-Angle Gauge SA9140E (or equivalent)
Torque: Front Strut-to-Knuckle (Initial Torque): 50 Nm (37 ft. lbs.)
Front Strut-to-Knuckle (Final Torque): 90 Nm (66 ft. lbs.) + 45° to 90°
5. Tighten lower control arm-to-steering knuckle. Hold bolt stationary and tighten nut.
Torque: Lower Control Arm-to-Steering Knuckle: 100 Nm (75 ft. lbs.)
IMPORTANT: Tie rod ends must be thoroughly cleaned before tightening nut.
6. Using Steering Linkage Installer J44015 (or equivalent) install the tie rod end into the steering knuckle.
Torque: Tie Rod End Linkage Installer: 45 Nm (33 ft. lbs.)
NOTICE: Use a new nut. Torque retention of old nut may not be sufficient.
NOTICE: Hold ball stud from turning when installing nut. The boot can become torn and damaged if the ball stud turns.