L300 V6-3.0L VIN R (2001)
^
If transaxle shift cable retaining tabs are properly seated and engaged in mounting bracket, obtain and install new transaxle shift cable retainer
clip (P/N 90522787).
^
If transaxle shift cable retaining tabs are not properly seated and engaged in mounting bracket, align and seat two retaining tabs in mounting
bracket. Then, obtain and install new transaxle shift cable retainer clip (P/N 90522787).
5.
Ensure transaxle shifts properly and vehicle only starts with transaxle shift lever in "P" (Park) and "N" (Neutral) positions.
6.
If it is necessary to adjust transaxle shift cable:
6.1
Place transaxle shift lever inside vehicle in "P" (Park) position.
6.2
Use a screwdriver, awl, or pick to lift adjustment lock tab on transaxle shift cable assembly.
6.3
Move underhood shift lever on transaxle to park position (position furthest away from front of dash area). There are detents inside transaxle
that create a positive feel of each transaxle gear position. Ensure that transaxle detent is fully engaged in park position.
6.4
Press adjustment lock tab back down to original position.
6.5
Check transaxle shifting to verify proper operation.
IMPORTANT:
Do not cover any existing underhood labels when affixing Campaign Completion Label.
7.
Affix Campaign Completion Label on a clean and dry surface of radiator core support, in an area clearly visible when hood is raised. (For more
information, refer to "CAMPAIGN COMPLETION LABEL" in this bulletin.)
