L300 V6-3.0L VIN R (2001)
4. Using Tie Rod Separator Tie Rod Separator SA91100C, separate tie rod end from steering knuckle.
5. Remove lower control arm to steering knuckle nut and bolt.
NOTICE: Be careful not to allow steering knuckle to contact ball stud seal. Contact may cause the seal to rip, requiring ball stud replacement.
IMPORTANT: Place a cloth over ball stud boot, protecting it from damage caused by contact with steering knuckle.
6. Separate lower control arm from steering knuckle.
NOTICE:
-
To prevent damage to CV joint boots, be careful not to allow them to contact other parts during removal and installation process. Also, never pull
on shaft assembly.
-
When removing the RH drive shaft, stub shaft may come out of transaxle with drive shaft. When this occurs inspect axle seal for damage and
replace if necessary.
7. Place a suitable container under the transaxle seal to collect any fluid before removing axle. Use pry bar to remove drive shaft from transaxle.