L300 V6-3.0L VIN R (2001)
1. Install control shaft lever assembly into vehicle and install retaining clips.
2. Install retaining pin that retains control shaft lever to shift control shaft of transaxle.
3. Tighten pinch bolt securing control assembly rod to control shaft lever assembly.
Torque: Control Arm Rod-to-Control Lever Arm Pinch Bolt: 12 Nm (9 ft. lbs.) + 180°
IMPORTANT: If transaxle hole plug was damaged during removal, install new plug during reassembly.
4. Release transaxle shift control shaft.
-
If transaxle has spring loaded locking pin, remove punch from shift lever and rock lever back and forth until lever can be moved freely.
-
If there was a plug in the transaxle hole, remove punch from shift lever, remove Shift Linkage Lock Pin 87-92-335, and reinstall plug
5. Install the hose clip to the two power steering lines.
