L Series V6-3.0L VIN R (2004)
8. Close the fuse block. Secure the latch (2).
9. Replace the fuse block cover. Secure the latch.
10. Snap the engine cooling hose into place on the cover.
11. Connect the battery feed to the fuse block.
12. Install the battery feed cover over the battery feed terminal.
IMPORTANT: Ensure that the battery tray is clean.
13. Install the battery. Refer to Battery Replacement in Starting and Charging.
IMPORTANT: Failure to use the battery foam shield will reduce the life of the battery.
14. Install the battery hold down/fan control module bracket bolt and bracket.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bracket bolt to 20 N.m (15 lb ft).
15. Slide the fan control module onto the battery hold down/fan control module bracket.