L Series V6-3.0L VIN R (2004)
Engine Control Module: Service and Repair
ENGINE CONTROL MODULE (ECM) REPLACEMENT
REMOVAL PROCEDURE
1. Turn the ignition OFF for at least 10 seconds.
2. Disconnect the ECM J1 and J2 harness connectors.
3. Remove the ECM attachment bolts and remove the ECM.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the ECM and the ECM attachment bolts.
Tighten the engine control module attachment bolts to 8 N.m (71 lb in).
2. Connect the ECM J1 and J2 harness connectors: