L Series V6-3.0L VIN R (2004)
7. Remove the blower motor resistor screws.
8. Use the electrical harness to pull the blower motor control module out of the HVAC module.
9. Disconnect the blower motor control module electrical connector.
INSTALLATION PROCEDURE
1. Connect the blower motor control module electrical connector.
2. Install the blower motor control module to the HVAC module.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the blower motor control module screws.
Tighten the screws to 1.0 N.m (9 lb in).
4. Connect the aspirator hose.