L Series V6-3.0L VIN R (2004)
Relay Box: Service and Repair
Underhood Electrical Center or Junction Block Replacement
UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT
REMOVAL PROCEDURE
1. Slide the fan control module up and off the bracket. With the wiring connected, set the fan control module aside.
IMPORTANT: The fan control module wiring does not need to be disconnected from the module. Additional wiring has been included in the
harness for diagnosis and service.
2. Remove the battery hold down/fan control module bracket bolt and bracket.
3. Remove the battery.
4. Uncover the battery feed on the fuse block cover.
5. Disconnect the battery feed to the fuse block.
6. Unsnap the engine cooling hose from the fuse block cover.
7. Push on the tabs at the end of the fuse block. Remove the cover (2) from the fuse block.
8. Push in the tabs (3) on the end of the fuse block case. Roll back the fuse block (1).