L Series V6-3.0L VIN R (2004)
9. Remove the upper starter assembly to engine block bolt.
10. Move the starter right, clearing the engine block, then left and out of the engine block (flywheel housing).
INSTALLATION PROCEDURE
1. Guide the starter into the engine block (flywheel housing).
2. Install the upper starter mounting bolt finger tight.
3. Raise the vehicle on a hoist.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the lower starter mounting bolts.
Tighten the lower starter mounting bolts to 40 N.m (30 lb ft).