LS2 V6-3.0L VIN R (2000)
13. Remove right hinge pillar molding (kick panel).
a. Remove the upper push pin fastener using a trim panel tool.
b. Remove fuse box door and pull on hinge pillar molding at clip location to disengage molding.
c. Slide hinge pillar molding out from under carpet retainer and remove hinge pillar molding.
14. Gain access to rear of radio and connect CD I/P harness to radio.
IMPORTANT: I/P harness connector, antenna connector, and ground strap terminal do not need to be disconnected, unless the radio needs to be
upgraded. Ensure connection.
a. Remove radio.
b. Upgrade radio (if necessary) to AM/FM stereo cassette player with equalizer (UL0) or AM/FM stereo cassette player and CD player with
equalizer (UP0).
c. Connect I/P CD jumper connector to rear of radio.
IMPORTANT: Do not secure radio or trim in place until CD changer/player is installed and verified to be functioning correctly.
d. Set radio into radio brace.