LS2 V6-3.0L VIN R (2000)
9. Remove four blower motor housing screws, release locking tabs and remove fan housing.
10. Disconnect blower motor electrical connector by squeezing bottom of connector and pulling downward.
11. Remove blower motor assembly by lifting straight out.
12. Hand tighten suction/liquid line assembly to TXV into TXV
13. Apply a thin coating of clean mineral oil on TXV to evaporator O-ring surfaces.
CAUTION: BLOWER RESISTOR CARD HAS SHARP EDGES AND MAY BE VERY HOT IF BLOWER WAS USED PRIOR TO
SERVICING.
14. Reach down through blower motor opening and locate evaporator pipes and block.
15. Install TXV into foam seal, dome end towards passenger's side of vehicle.