LS2 V6-3.0L VIN R (2000)
CAUTION: Never Drain Or Store Fuel In Any Open Container Due To The Possibility Of Fire Or Explosion.
CAUTION: Make Sure Vehicle Is Properly Supported And Squarely Positioned. To Help Avoid Personal Injury When A Vehicle Is On A Hoist,
Provide Additional Support For The Vehicle On The Opposite End From Which Components Are Being Removed.
1.
Position vehicle on hoist.
CAUTION: Fuel Supply Lines Will Remain Pressurized For Long Periods Of Time After The Engine Is Shutdown. This Pressure Must Be Relieved
Before Servicing The Fuel System.
2.
Relieve fuel system pressure.
a.
Connect Scan tool to vehicle diagnostic connector and start vehicle.
b.
Use Scan tool to command fuel pump Off. (Refer to Tech 2 User Guide for proper Scan tool navigation and setup.)
c.
Engine will stall in 3-5 seconds.
3.
Raise vehicle on hoist to comfortable working height, keeping Scan tool outside of vehicle and accessible from under vehicle.
CAUTION: Whenever Fuel Line Fittings Are Loosened, Wrap A Shop Cloth Around The Fitting And Have An Approved Container Available To
Collect Any Fuel.
4.
Disconnect fuel feed line at outlet to fuel filter.
5.
Install 3/8" x 1/4" quick connect (1) adapter from flow/pressure adapter (SA9127E-7) into fuel feed line.
6.
Connect suitable drain hose to other end of adapter, and connect drain hose to certified fuel handling cart.
7.
Energize fuel pump using Scan tool. (Refer to Tech 2 User Guide for proper Scan tool navigation and setup.)
8.
Pump out fuel until no more fuel flows from line.
9.
Lower vehicle.
REMOVE FUEL TANK
CAUTION: Do Not Allow Smoking Or The Use Of Open Flame In The Area Where Work On The Fuel System Is Taking Place.
CAUTION: Any Time The Fuel System Is Being Worked On, Disconnect The Negative Battery Cable, Except For Those Tests Where Battery Voltage
Is Required.
1.
Disconnect negative battery cable.
2.
Raise vehicle to a comfortable working position.
