LS2 V6-3.0L VIN R (2000)
3. On vehicles equipped with rear disc brakes, perform the following steps:
NOTICE: Clean caliper support bracket fasteners thoroughly with brake and choke cleaner (P/N 21007432 or equivalent). Apply thread locker
Loctite(R) 272 (or equivalent) to caliper support bracket fasteners. If Loctite(R) 272 (or equivalent) is not available, new caliper support bracket
fasteners must be used.
a. Install caliper to rear axle control arm, tighten fasteners.
Torque: 80 Nm (59 ft. lbs.)
b. Connect brake pipe support bracket to control arm.
Torque: 8 Nm (71 inch lbs.)
IMPORTANT: Be sure that electrical connector is fully seated and latch is engaged.
4. Connect A13S sensor electrical connector.