LW100 L4-2.2L VIN F (2002)
1. If the rear shelf panel is being replaced, transfer the latch insulators from the rear seat back to the new shelf panel.
2. Position the rear shelf panel to the vehicle. Verify that the rear seat back insulators are properly installed over the seat back latch brackets.
3. Push on the rear portion of the shelf panel to engage the rear retainers.
4. Install the remaining push-pin fasteners.
5. Install the rear upper garnish moldings. Refer to Rear Upper Garnish Molding Replacement (See: Trim Panel/Service and Repair/Rear Upper
Garnish Molding Replacement).
6. Raise the rear seat back assemblies.