LW100 L4-2.2L VIN F (2002)
Power Seat Switch: Procedures
Heated Seat Switch Replacement
REMOVAL
1. Partially remove center trim plate by pulling at clip locations to disengage clips. Tilt trim plate sideways to access back of trim plate.
2. Disconnect left heated seat/fog switch and/or traction/right heated seat switch electrical connector(s).
3. Remove switch(es) by disengaging attaching clips.
INSTALLATION
1. Install switch(es) by snapping into place.
2. Connect wiring harnesses to switch(es).
3. Position center trim plate and secure to instrument panel by gently pushing at attaching clip locations.
Power Seat Switch Replacement
REMOVAL